Use; The Control Panel - Zanussi TCE 7276 Instruction Booklet

Tumble dryer tce 7276
Hide thumbs Also See for TCE 7276:
Table of Contents

Advertisement

Use

The control panel

1 Programme guide
This will help you to select the correct programme
for drying.
2 DOOR OPENING button
Press this button to open the door. The light above
the button will light up.
Opening the door by means of this button is
possible only if the tumble dryer is on
(programme selector dial set to a programme or
drying time).
If you open the door during a programme, in order
to restart the programme you must press the
START/PAUSE button again after having closed the
door.
3 Buzzer OFF button
A buzzer sounds
• when selecting the programme
• when depressing the buttons
• when an incorrect option selection is made
• when the programme selector dial is turned to
another position during the programme or when
you depress an option button during the cycle
• during the anti-creasing phase
• at the end of the programme
• when the water reservoir is full
• if the machine is not working correctly
• when the small door at the bottom is open
By depressing button
switched off.
The corresponding light comes on.
the acoustic signal is
4 Quick drying button
By depressing this button the drying time is reduced
in the following COTTON programmes:
• extra dry
• ready to wear
• store dry
The corresponding light illuminates. This option
cannot be selected together with "low temperature"
function
.
5 Low temperature button
Pressing this button allows drying to be performed
at a lower temperature, for delicate items.
The corresponding pilot light comes on.
This option can also be used for time controlled drying.
This function cannot be used with QUICK DRYING.
6 DELAYED START button
This button allows you to delay the starting of the
programme by 12 hours max.
This option must be selected after having selected
the programme and before pressing START/PAUSE
to start the programme.
Every time the button is pressed, the time is
increased by 30 minutes, until the display shows a
delay of "2 hours". After this, the delay is displayed
hour by hour.
The minutes or hours of delay that have been
selected are displayed for 2 seconds, then the
display shows the duration of the previously
selected programme.
The countdown begins after you have pressed the
START/PAUSE button.
To cancel the delay time press the DELAYED START
button until the display indicates
START/PAUSE button again.
6
0'h
. Then press the

Advertisement

Table of Contents
loading

Table of Contents