Adjusting The Worktop; Fitting Under A Counter - Zanussi DISHWASHER Instruction Booklet

Adjusting the worktop

You can move the worktop forward or backward by
25 mm in order to align the machine with other
kitchen units.
Simply unscrew the two rear retaining screws,
move the top to the required position and then
retighten the screws.

Fitting Under a Counter

(kitchen worktop or sink)
By removing the machine's worktop, you can install
it under a close fitting sink unit or a pre-existing
top, providing the dimensions of the recess
correspond to those shown in the picture.
Proceed as follows:
Remove the machine's worktop by unscrewing the
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and
levelling with the adjustable feet. When inserting
the machine, ensure that the water inlet and drain
hoses are not kinked or squashed.
Fitting a decor panel on the door
The door of this machine has frames for fitting a
plastic laminate decor panel in the colour required
to match the dishwasher with the rest of the kitchen
furniture. If you wish to do this you must provide
the panel yourself, that must have the following
dimensions.
Width: 588 mm
Height: 586 mm
Max thickness: 4 mm
To fit the panel
Take the door frame off after removing the retaining
screws around the edge.
Position the panel, refit the frame and tighten the
retaining screws around the edge.
Note:
The panel should be fitted before positioning
the machine.
IN26
IN05
AP01
45 PFI01GB