Table of Contents
Advertisement
Electrical connection
Information concerning the electrical connection is given on
the rating plate on the edge of the dishwasher's door on the
right.
Before plugging the appliance into the wall socket, make sure
that:
1. The mains voltage and current rating at the site of
installation match the nominal voltage and current rating
given on the rating plate.
2. The meter, fuses, mains power supply and wall socket can
all take the maximum load required. Make sure that the
socket and plug are compatible without having to use any
type of adaptor. If necessary, have the domestic wiring
system socket replaced.
To isolate the dishwasher from mains, remove the mains plug.
Hints for test centres
Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing
programmes" chart).
Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt
and rinse aid respectively and using the test programme (see "Washing programmes" chart).
Arrangement upper basket
Load:
Rinse aid setting
Rinse aid dispenser (type A):
Rinse aid dispenser (type B):
Detergent dosage :
Arrangement cutlery basket
Arrangement cutlery basket
Important!
The plug must still be accessible after the appliance has
been installed.
In case that the electrical cable has to be replaced, please
contact your local consumer services department.
Safety standards require the appliance to be earthed.
The manufacture accepts no liability for failure to observe
the above safety precautions.
12 standard place settings
position 4 (Type III)
position 5 (Type III)
5 g + 25 g (Type B)
35
Arrangement lower basket
Advertisement
Table of Contents
