Dairy compartment Ventilation grille Door shelf + box Door shelf Control Panel A. Green indicator lamp B. Thermostat control Lights when the fridge is operating. Use to switch on and set the desired temperature in the fridge. Zanussi 818 18 84-01/9...
This will reflect the temperature inside the food products. Do not place the thermometer hanging or lying directly on the shelf. Zanussi 818 18 84-01/9...
· Make sure the door gasket is complete and compressor to switch on unnecessarily often. always clean. · Ensure there are no obstructions preventing the door from closing properly. Zanussi 818 18 84-01/9...
When moving the cabinet, lift it by cleaner, as an accumulation of dust will affect the the front edge to avoid scratching the performance of the appliance and cause excessive floor. electricity consumption. Zanussi 818 18 84-01/9...
Water comes out on the floor. Place the drain hose at the back of the cabinet above the drain bowl. See the chapter "Before using the cabinet the first time". Zanussi 818 18 84-01/9...
Parts replaced free of charge become our 10. Appliances that are easy to transport may be property. delivered or sent to the consumer services 3. So as to avoid more severe damage, the defect Zanussi 818 18 84-01/9...
Unpack the cabinet and check that it is in good condition and free of any transport damage. Notify the dealer immediately of any damage. Hand the packaging over for recycling. For more information, contact your local city office or the dealer. Zanussi 818 18 84-01/9...
10 mm to allow discharges into the drip tray. the door to open enough so that the shelves can be The power plug must be accessible after installation removed. of the cabinet. Zanussi 818 18 84-01/9...
8. Put the cabinet in position. Check that it stands straight. See the section "Positioning the cabinet". Electrical connection Connect the cabinet to a grounded electrical outlet. Voltage: 230 V. Fuse: 10 A. Refer to the rating plate on the left inside the cabinet. Zanussi 818 18 84-01/9...