Sony Ericsson V640i White Paper page 31

Service
SET UP MENU
TIMER MANAGEMENT
OPEN CHANNEL
CLOSE CHANNEL
RECEIVE DATA
SEND DATA
GET CHANNEL STATUS
rëÉê=fåíÉê~Åíáçå=ïáíÜ=pfj=^q
aáëéä~ó=íÉñí
Text of up to 240 characters (120 UCS coded) is
supported.
Text clearing times are 5–20 seconds with a 60-
second time-out limit for the user to clear the text.
'Key' responses:
• 'End key' – Proactive session terminated by
user.
• 'Back' – Backward move in proactive session.
Any other key clears the screen if the command is
performed successfully.
dÉí=áåâÉó
Prompt for a one-character input. Pressing 'Ok'
without entering a character gives warning mes-
sage "Minimum 1 character". 'Key' responses:
• 'C' clears current character.
• 'End key' terminates the proactive session.
• 'Back' – Backward move in proactive session.
• 'OK' – Command performed successfully.
dÉí=áåéìí
Prompt for character input. The phone will refuse to
accept further input when maximum response
length is exceeded. UI Maximum Response
lengths:
• Digits Only – 160 characters.
• SMS default alphabet characters – 160 charac-
ters.
Mode
• Hidden Characters (digits only) – 20 characters.
'Key' responses:
• 'C' clears current character.
• 'End key' terminates the proactive session.
• 'Back' – Backward move in proactive session.
• 'OK' – Command performed successfully.
pÉäÉÅí=áíÉã
Scroll to highlight item for selection. 'Key'
responses:
• Navigational key press down – Scroll down list.
• Navigational key press up – Scroll up list.
• 'End key' terminates proactive session.
• 'Back' – Backward move in proactive session.
• 'OK' – Command performed successfully.
pÉåÇ=ëÜçêí=ãÉëë~ÖÉ
Default message "Sending message, please wait"
can be replaced for the Alpha Identifier text, or
suppressed completely if a null text is provided.
Default responses are "MESSAGE FAILED" or
"MESSAGE SENT". 'Key' responses:
• 'End key' or 'Back' ends the proactive session.
pÉí=ìé=Å~ää=
If you are on a call when the commands 'Set up
Call', 'putting all other calls on hold' are sent, the
user will see the text 'Setting up a call current call
will be held'. If 'OK' is pressed the current call will
be put on hold and the new call set up. If you are
on a call when the command 'Set Up Call, discon-
necting all other calls' is sent, the user will see the
31
White paper V640i
Support
Yes
Yes
Yes
Yes
Yes
Yes
Yes
October 2007