Overview Of Bios Features; Introduction - Intel DG41TY Technical Product Specification

3

Overview of BIOS Features

3.1

Introduction

The board uses an Intel BIOS that is stored in the Serial Peripheral Interface Flash
Memory (SPI Flash) and can be updated using a disk-based program. The SPI Flash
contains the BIOS Setup program, POST, the PCI auto-configuration utility, and Plug
and Play support.
The BIOS displays a message during POST identifying the type of BIOS and a revision
code. The initial production BIOSs are identified as TYG4110H.86A
When the BIOS Setup configuration jumper is set to configure mode and the computer
is powered-up, the BIOS compares the CPU version and the microcode version in the
BIOS and reports if the two match.
The BIOS Setup program can be used to view and change the BIOS settings for the
computer. The BIOS Setup program is accessed by pressing the <F2> key after the
Power-On Self-Test (POST) memory test begins and before the operating system boot
begins. The menu bar is shown below.
Maintenance Main
NOTE
The maintenance menu is displayed only when the board is in configure mode.
Section 2.3 on page 53 shows how to put the board in configure mode.
Advanced Security
.
Power Boot Exit
61