Gigabyte GA-X79-UD3 User Manual page 93

Refer to the following for installing the driver during the Windows setup process.
Step 1:
Restart your system to boot from the Windows XP setup disk and press <F6> as soon as you see the message
"Press F6 if you need to install a 3rd party SCSI or RAID driver." A screen will then appear asking you to specify
an additional SCSI adapter. Press <S>.
Step 2:
Insert the loppy disk containing the SATA RAID/AHCI driver and press <Enter>. Select either the 32-bit or
64-bit items depending on whether you want to install the 32-bit or 64-bit version of Windows XP (Figure 4).
Both of the Marvell shared library and Marvell 91xx SATA Controller need to be installed. Below we assume
that you are installing the 32-bit version. First select Marvell shared library for 32bit (install irst) and press
<Enter>. On the next screen, press <S> to return to the screen in Figure 4. Then select Marvell 91xx SATA
Controller 32bit Driver and press <Enter>. When both of the two drivers appear on the conirmation screen,
press <Enter> to continue the driver installation.
Windows Setup
You have chosen to conigure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select
Step 3:
On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can proceed
with the Windows XP installation.
Marvell shared library for 32bit (install irst)
Marvell 91xx SATA Controller 32bit Driver
Marvell shared library for 64bit (install irst)
Marvell 91xx SATA Controller 64bit Driver
F3=Exit
Figure 4
- 93 - Appendix