Electrical Connections - Zanussi FL 882 Instruction Booklet

ELECTRICAL CONNECTIONS

WARNING: THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should this
safety measure not be observed.
If the plug that is fitted to your appliance is not suitable for
your socket outlet, it must be cut off and the appropriate
plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to prevent the
hazard of shocks in case it should be plugged into a 13
amp socket in another part of your home.
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Green and yellow
Blue
Brown
If you fit your own plug, the colours of the wires in ghe
mains lead of your appliance may not correspond with the
markings identifying the terminals in your plug, proceed as
follows:
Connect the green and yellow (earth) wire to the terminal in
the plug which is marked with the letter ÒEÓ or the earth
symbol or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the plug
which is marked with the letter ÒNÓ or coloured black.
- Earth
- Neutral
- Live
Connect the brown (live) wire to the terminal in the plug
which is marked with the letter ÒLÓ or coloured red.
The plug moulded onto the lead incorporates a fuse. For
replacement, use a 13 amp BS1362 fuse. Only ASTA or
BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost.
The cover/carrier is indicated by the coloured insert at the
base of the plug.
A replacement cover/carrier must be obtained from your
local Zanussi Service Centre whose address can be found
in the accompanying Customer Care Booklet.
7