Honeywell TB7200 Series Wireless Installation & Integration Reference Manual page 17

WIRELESS INSTALLATION & INTEGRATION REFERENCE GUIDE FOR TB7200/TB7300/TB7600 SERIES THERMOSTATS
Adding Thermostats to a Station
This section describes how to add wireless thermostats to a station.
1. Double click on the WirelessTstatNetwork in the Nav pane.
2. Click on the Discover button, and click OK. If desired, you can enter the lowest and highest thermostat Com Addr number
in the Device Low Limit and Device High Limit text boxes if you want to limit the number of devices discovered.
All thermostats that have been properly configured with a unique Com Addr, the network PAN ID and network Channel and that
are powered up will be discovered.
The "Discovered Device" folder lists the current thermostats and repeaters detected by the WEBs-AX controller that have the
same PAN ID and Channel settings as the WEBs-AX controller. A Yellow highlight indicates a previously discovered thermostat
that has not updated it's mandatory wireless heartbeat to the WEBs-AX controller and is now offline to the WEBs-AX controller.
If a properly configured thermostat has issues joining the network and cannot be discovered by the WEBs-AX controller (typically
the ones farthest from the WEBs-AX controller), a forced sync can be done by right clicking on the WirelessTstatNetwork driver
extension and selecting "ping." Bringing the device close to the WEBs-AX controller or another device that has already joined the
17 63-4522—02