Drying Only; Automatic Washing And Drying - Zanussi WJE 1200 User Manual

Drying only

Warning! Do not exceed the maximum laundry
loads:
- 2.5 kg or 3 kg depending on the model for linen
and cottons
- 2 kg for synthetics.
The water tap must be open and the drain hose must
be positioned in the sink or connected to the drain
pipe.
1. Press the RESET button repeatedly to erase the
programme that has just been carried out.
2. Switch the machine off by depressing ON/OFF
button.
3. Load the laundry
4. Depress the ON/OFF button
machine on.
5. If you wish to carry out the electronic drying,
depress button
corresponding to the degree of dryness required
illuminates.
6. If you want a timed drying, depress button
until light COTTONS
lights up, then depress the same button until the
time you want appears on the display.
7. Press the START/PAUSE button
programme.
8. At the end of the cycle, press RESET button to
clear the memory and press the ON/OFF button
again to switch the appliance off.
9. Remove the laundry.
to switch the
until the pilot light
or SYNTHETICS
to start the

Automatic washing and drying

(NON-STOP programme)
Warning! For NON-STOP programmes, it is also
essential not to exceed the maximum load sizes of
2.5 kg or 3 kg for cotton and 2 kg for synthetics.
Do not use a dosing device/ball when carrying
out a washing & drying programme.
1. Load the laundry.
2. Add detergent and additive.
3. Switch the machine on by depressing the
ON/OFF button
4. Select the wash programme.
5. Select eventually the required options by means
of the relevant buttons. If possible, do not select a
spin speed lower than that proposed by the
appliance to avoid a too long drying time so
saving energy.
In any case the reduction of the spin speed is
only possible after selecting drying. The lowest
values you can select are the following:
- 900 r.p.m. for cottons & synthetics with
electronic drying
- 900 r.p.m. for cottons and 700 r.p.m. for
synthetics with timed drying
6. Select the drying time or degree of drying.
7. Start the programme by depressing the
START/PAUSE button.
8. At the end of the programme, press the RESET
button to clear the memory and press the
ON/OFF button again to switch the machine off.
9. Remove the laundry.
22
.