Download Print this page
Casio 5347 Operation Manual

Casio 5347 Operation Manual

Oc

Advertisement

Quick Links

MA1402-EB
About This Manual
Operations are performed using the watch's crown, and the two buttons
Upper dial
indicated by the letters A and B in this manual.
Hand Functions
1 1 Hour Hand
2 2 Second Hand
3 3 Minute Hand
4 4 Upper Dial Big Hand
5 5 Upper Dial Small Hand
6 6 Lower Dial Big Hand
7 7 Lower Dial Small Hand
8 8 Mode Hand
9 9 Day Indicator
Lower dial
This User's Guide uses numbers shown above to identify watch hands and indicators.
Hand and Date Indicator Movement
9 Day Indicator movement is coordinated with 8 Mode Hand movement. When changing the 9 Day
Indicator setting, the 8 Mode Hand will also rotate.
The 9 Day Indicator changes gradually at midnight. It takes anywhere from about 90 seconds to three
minutes for the day to change. The 8 Mode Hand will rotate when the 9 Day Indicator changes.
The day may not be displayed correctly while the crown is pulled out.
The Home City date is displayed in the Timekeeping Mode and the Stopwatch Mode. The World Time
City date is displayed in the World Time Mode (page E-23).
E-2
To start HS1 high-speed movement
While the crown is pulled out, rotate it rapidly three turns away from you (for
forward movement) or towards you (for reverse movement). High-speed
movement will continue even if you release the crown.
To start HS2 high-speed movement
While HS1 high-speed movement is progress, again rotate the crown rapidly
three turns in the same direction as the current HS1 movement (away from you
for forward movement or towards you for reverse movement).
To stop high-speed movement
Rotate the crown in the direction that is opposite that of the current high-speed
movement or press any button.
Important!
Leaving the crown pulled out for more than two minutes (approximately 30 minutes in the case of hand
and day home position adjustment) without performing any operation will automatically cause crown
operations to become disabled. If this happens, press the crown back in, pull it out, and then start the
operation over again.
E-4
5. Check the Home City.
Use the procedure under "Selecting a City" (page E-28) to confi gure your Home City.
Important!
Proper time calibration signal reception depends on correct Home City, time, and date settings in the
Timekeeping Mode. Make sure you confi gure these settings correctly.
6. Set the current time.
To set the time using a time calibration signal
See "To get ready for a receive operation" (page E-16).
To set the time manually
See "Confi guring Current Time and Date Settings Manually" (page E-32).
The watch is now ready for use.
For details about the watch's radio controlled timekeeping feature, see "Radio Controlled Atomic
Timekeeping" (page E-13).
E-6
Operation Guide 5347 (OC)
Congratulations upon your selection of this CASIO watch.
Note that the product illustrations in this manual are intended for reference only, and so the actual
product may appear somewhat different than depicted by an illustration.
This watch does not have a city code that corresponds to the UTC offset of –3.5 hours. Because of
this, the radio-controlled atomic timekeeping function will not display the correct time for Newfoundland,
Canada.
Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage or loss suffered by
you or any third party arising through the use of this product or its malfunction.
Crown Operations
The crown can be pulled out to one of two (click) positions. Never apply undue force when pulling out the
crown.
Important!
In order to ensure full water resistance and to prevent damage due to impact, make sure that the crown
is normally pushed in fully when using the watch.
When pulling out the crown, avoid using undue force, which creates the risk of personal injury to your
fi ngers and fi ngernails, and of watch malfunction.
First click
Second click
High-speed Movement
When setting a time or when performing home position adjustment (page E-39), you can move the hands
either forward or back at high speed. There are two high-speed levels: HS1 and HS2 (faster than HS1).
Things to check before using the watch
1. Pull the crown out to the fi rst click.
2. Hold down B for at least two seconds to enter the Timekeeping Mode.
3. Push the crown back in.
4. Observe the movement of the 2 Second Hand.
Is the 2 Second Hand moving smoothly at one-second intervals?
NO
Is the 2 Second Hand moving at two-second intervals
or is it stopped completely?
YES
Power is low. Charge the watch by placing it in a
location where it is exposed to light. For details, see
"Charging the Watch" (page E-9).
Contents
About This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-2
Crown Operations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-3
Things to check before using the watch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-5
Charging the Watch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-9
To recover from the sleep state . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-12
Radio Controlled Atomic Timekeeping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-13
To get ready for a receive operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-16
To perform manual receive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-18
To check the result of the latest receive operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-19
To turn auto receive on and off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-20
Mode Reference Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-22
Selecting a City . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-28
To select a city . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-28
To switch between standard time and summer time manually . . . . . . . . . . . . . . . . . . . . . . . . . . . E-31
ENGLISH
E-1
E-3
YES
The watch is charged. For details about
charging, see "Charging the Watch"
(page E-9).
NEXT
Go to step 5.
E-5
E-7

Advertisement

loading

Summary of Contents for Casio 5347

  • Page 1 Newfoundland, Canada. Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage or loss suffered by you or any third party arising through the use of this product or its malfunction.
  • Page 2: Charging The Watch

    Operation Guide 5347 (OC) Confi guring Current Time and Date Settings Manually ........E-32 Charging the Watch To change the current time and date setting manually .
  • Page 3: Mode Reference Guide

    Operation Guide 5347 (OC) To get ready for a receive operation Signal reception may be diffi cult or even impossible under the conditions described below. 1. Enter the Timekeeping Mode (page E-24). You could also enter the World Time Mode to perform this procedure.
  • Page 4: Selecting A City

    Operation Guide 5347 (OC) General Guide World Time Mode Pull out the crown to the fi rst click and then rotate it to navigate between modes. Push the crown back in World Time A button after entering the mode you want.
  • Page 5: Confi Guring Current Time And Date Settings Manually

    Operation Guide 5347 (OC) Confi guring Current Time and Date Settings Manually 2. Change the city setting and summer time setting, if you want. To change the city setting, perform step 2 under “To select a You can confi gure current time and date settings manually when the watch is unable to receive a time city”...
  • Page 6 Operation Guide 5347 (OC) Hand/Day Adjustment Steps To adjust the hand and day home positions For full details, see the procedure from page E-41 to E-43. Important! Pull crown out to second click. You do not need to perform the procedure in this section if the watch is indicating the time and/or day correctly.
  • Page 7: Specifications

    Operation Guide 5347 (OC) Specifi cations Crown Operation ■ Nothing happens when I rotate the crown. Accuracy at normal temperature: ±15 seconds a month (with no signal calibration) Timekeeping : Hour, minutes, seconds, a.m./p.m. indication, day, day of the week...