The Control Panel - Zanussi TS662 Instruction Book

4. USING

4.1. The control panel

1 - On/Off pushbutton
2 - Cold wash pushbutton
1 2 3
4.2. How to do a wash ?
Before the first wash in your washing machine, we recom-
mend that you should do a preliminary wash at 90°C with de-
tergent but without any washing to clean the tub.
4.2.1. Loading the washing
• Lift the machine cover.
• Open the drum by pressing on the locking button A; the
two flaps automatically separate.
• Insert the washing, close the drum and the cover of your
washing machine.
A
4.2.2. Proportioning of detergents
Your washing machine was designed to reduce water and
detergent consumption, therefore reduce the doses recom-
mended by detergent manufacturers.
Pour the powder detergent dose into the wash compartment
and into the prewash compartment
«prewash» option. Pour in the softener into the
ment if you wish.
If you are using a different type of detergent, refer to the «de-
tergents and additives» section in the washing guide.
Warning : before you close the
cover of your washing machine,
make sure that the drum door is
properly closed:
•the two flaps latched together,
•the locking button A extended.
if you chose the
3 - Rinse hold pushbutton
4 - Program selector
4
4.2.3. Choice of the pushbuttons
Press the chosen pushbuttons.
4.2.3.1. «On/off» pushbutton
To switch on your appliance, press this pushbutton. The
control lamp lights on.
4.2.4. «Cold wash» pushbutton
This pushbutton is used for cold washing ; water input the
drum is not heated.
4.2.5. «Rinse hold» pushbutton
If you use this pushbutton, the tub remains full of water at the
end of the last rinse to prevent the washing from becoming
creased if it is not taken out of the drum as soon as the
washing machine is stopped.
4.2.6. Choice of the programme
Select the program depending on the nature and the degree
of soil of the laundry.
Turn the program selector clockwise to select the chosen
programme.
4.2.7. Starting the program
After you choose the washing program, press the «On/Off»
pushbutton to start the cycle.
compart-
4.2.8. End of the programme
When the chosen programme is over, the washing machine
stops automatically and the programme selector stays on
the stop «I» or «rinse hold» position.
The programmes end :
• by a spinning for the cotton programmes.
• by a drain (for the synthetics programmes) if you have
not pressed the «rinse hold» pushbutton.
3