Using Your Dco7 - Dyson DCO7 Owner's Manual

16852_DCO7_OP_MAN_US.qxd

Using your DCO7

WARNING
• This machine is intended for
domestic use only. Fine dust
such as plaster dust or flour
should only be vacuumed in
small amounts.
• Consult your flooring
manufacturer's instructions
before vacuuming your
flooring, rugs and carpets.
Some carpets will fuzz if a
rotating brushbar is used when
vacuuming. If this happens we
recommend vacuuming in
bare floors mode and
consulting with your flooring
manufacturer.
CAUTION
• Keep hair, loose clothing,
fingers, and all parts of the
body away from openings
and moving parts.
• This machine is fitted with
a belt protection system.
If any item becomes caught
in the brushbar (e.g., rug
fringe), you will hear a loud
"ratcheting" warning noise.
To rectify, turn the machine
off, disconnect from the
electrical outlet, and clear
any obstruction (see page 14),
checking that the brush control
is set to the correct position
for the floor surface before
re-starting the machine.
tip The ratcheting noise may also
occur if your carpet or area
rug is not adequately attached
to the floor. If this happens
you should vacuum in bare
floors mode.
Dyson Helpline
6
5/7/07 14:00 Page 6 (Black plate) (Yellow plate) (PANTONE (Magenta (Cyan plate)
contact us at
10:39:28 2007-07-06 C_16852_DCO7_OP_MAN_US_4c1s.pdf
plate) Red 032 C plate)
1
2
Switching on/off
1 Make sure you have read
and understood all safety
instructions before using the
machine for the first time.
The wand cap should be
closed when not using the
tools.
2 Plug into electrical outlet and
press the on/off switch.
1 - 866 - 693 - 9766
3
3 To start vacuuming, push the
front of the cleaner head down
with your foot and tilt the
handle backward.
7 days a week