Controlling; Odules; T O Set The X-10 Sleep Timer; Changing The X-10 House Code - X-10 UR19A SuperRemote Owner's Manual

C
ONTROLLING
X-10 M

ODULES

If you have purchased and installed a
Transceiver Module, you can control it
and other X-10 modules as follows:
1. Press and release
the X-10 button.
2. Use the number
buttons to enter the
Unit Code number
of the chosen
module. (You do
not need to enter
'0' first for a single
digit number.)
3. Press the appro-
priate button for the
function you require
(see below).
X-10 FUNCTIONS:
On: CHANNEL +
Off: CHANNEL –
Bright: VOLUME +
Dim:
All Lamps On:
All Modules Off:
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
T X-10 S
O SET THE LEEP
The X-10 Sleep Timer switches off the
chosen modules after the preset time.
1. Press and release
the X-10 button.
2. Press and hold
TIMER until the LED
indicator lights
steadily. Release
TIMER button.
26
3. Use the number
buttons to enter the
module Unit Code
for the module to
be turned off.
4. Press the desired
function button (e.g.
CHANNEL - to turn
the module off after
the preset time).
5. Using the number
buttons enter the
sleep time required
(1 to 99 mins).
6. Press ENTER to
confirm the setting.
C
HANGING THE
C :
ODE
VOLUME –
The SuperRemote defaults to House Code
POWER
A, and in most cases you will not need to
MUTE
change this unless you are experiencing
interference from a neighboring X-10
system.
1. Press and release
the X-10 button.
T
IMER
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Use the number
buttons to enter the
number equivalent
to the chosen
House Code
(1=A, 2=B ..16=P).
X-10 H
OUSE
27