Launching The Watercraft - Yamaha GP1300R WaveRunner 2006 Owner's/Operator's Manual

1. Launch the watercraft and start the
engine. (See page 3-18 for engine start-
ing procedures.)
2. Run the engine at the lowest possible
speed for 5 minutes.
3. Gradually open the throttle and run the
engine at 5,000 r/min or less.
4. Continue operation at 5,000 r/min or less
until the first tankful of fuel has been
used.
5. Fill the tank with straight gasoline, and
then proceed with normal operation.
CAUTION:
@
Failure to follow the engine break-in pro-
cedure properly can result in severe
damage to the engine.
@
EJU21720

Launching the watercraft

When launching the watercraft, make
sure that there are no obstructions around
you.
After the watercraft is in the water, turn it
around so the bow faces the direction you
want to go. Start the engine, and then slowly
move away from the launching area. If there
are waves, someone should make sure that
the watercraft is not pushed into the trailer
after launching the watercraft.
3-17
E