Yamaha FX High Output WaveRunner 2007 Owner's/Operator's Manual page 52

Features and functions
check engine warning indicator begin to blink,
and the buzzer sounds intermittently.
If this occurs, reduce the engine speed, return
to shore, and have a Yamaha dealer check
the engine.
NOTE:
Press any button on the multifunction meter to
stop the buzzer.
EJU35032
Right multifunction display and operation
buttons (for FX Cruiser High Output)
The right multifunction display shows the fol-
lowing information.
Compass
G
Average speed
G
Tripmeter
G
Trip timer
G
Fuel consumption per hour
G
Fuel consumption per kilometer/mile
G
Water temperature
G
Air temperature
G
47
The following operation buttons are on the
right side of the multifunction meter.
1 "Mode/Reset" button
2 "Start/Stop" button
To switch the display mode, push the
"Mode/Reset" button for less than 1 second.
The display mode changes in the following or-
der.
Compass → Average speed → Tripmeter →
Trip timer → Fuel consumption per hour →
Fuel consumption per kilometer/mile → Water
temperature → Air temperature
NOTE:
To switch the display units between kilome-
G
ters/liters/degrees Celsius and miles/gal-
lons/degrees Fahrenheit,
"Volt/Hour" button for at least 1 second,
within 10 seconds after the multifunction
meter starts operating.
The "SPEED" indicator light blinks three
G
times if miles/gallons/degrees Fahrenheit
are selected as the display units when the
multifunction meter starts operating, or if
push the