Yamaha Road Stan XV17AT Owner's Manual page 72

PERIODIC MAINTENANCE AND MINOR REPAIR
To adjust the drive belt slack
1. Loosen the rear wheel axle nut
and the brake caliper bracket bolt.
1. Axle nut
6
1. Brake caliper bracket bolt
2. Loosen the drive belt puller locknut
on each side of the swingarm.
EAU23070 3. To tighten the drive belt, turn the
adjusting bolt on each side of the
swingarm in direction (a). To loos-
en the drive belt, turn the adjusting
bolt on each side of the swingarm
in direction (b), and then push the
rear wheel forward.
NOTE:
Turn each adjusting bolt the same
amount for proper wheel alignment.
1. Drive belt slack adjusting bolt
2. Locknut
3. Wheel axle
4. Tighten the locknuts.
6-27
CAUTION:
Improper drive belt slack will over-
load the engine. Keep the drive belt
slack within the specified range.
5. Tighten the axle nut and the brake
caliper bracket bolt to the specified
torques.
Tightening torques:
Axle nut:
150 Nm (15.0 m·kgf, 108.5 ft·lbf)
Brake caliper bracket bolt:
48 Nm (4.8 m·kgf, 34.7 ft·lbf)
ECA10880