Yamaha GRIZZLY 660 Owner's Manual page 143

1. Coolant reservoir drain hose
9. After draining the coolant, thoroughly
flush the cooling system with clean tap
water.
10. Replace the coolant drain bolt washer if it
is damaged, install the coolant drain bolt,
and then tighten it to the specified torque.
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7 ft·lbf)
11. Install the coolant reservoir hose.
12. Pour the recommended coolant into the
reservoir to the maximum level mark, and
then install the reservoir cap and panel D.
13. Pour the recommended coolant into the
radiator until it is full, and then install the
radiator cap.
Recommended antifreeze:
High quality ethylene glycol antifreeze
containing corrosion inhibitors for
aluminum engines.
Antifreeze and water mixing ratio:
1:1
Total amount:
1.8 L (1.58 Imp qt, 1.90 US qt)
Coolant reservoir capacity
(up to the maximum level mark):
0.3 L (0.26 Imp qt, 0.32 US qt)
8-29