Checking Bolts And Nuts; Motor Exterior; Cleaning Cooling-Water Passages - Yamaha 60A Owner's Manual

90
e
EML40010

CHECKING BOLTS AND NUTS

1) Check that bolts securing the cylinder
2) Check the tightening torques of other
EMU00409

MOTOR EXTERIOR

EMU00410
Cleaning the Outboard Motor
After use, wash the exterior of the out-
board with fresh water.
Flush the cooling system with fresh
water.
NOTE:
Refer to Flushing Cooling System instruc-
tions in "TRANSPORTING AND STORING
OUTBOARD MOTOR".
102024
EMU01172
CLEANING COOLING-WATER
q
PASSAGES
Flushing device equipped model
Perform this procedure right after opera-
tion for the most thorough flushing.
1) After shutting off the engine, unscrew
w
2) Screw the garden-hose connector 2
3) With the engine off, turn on the water
4) When flushing is complete, reinstall
000841
4-26
head and engine and the nut securing
the flywheel are tightened with their
specified tightening torques.
bolts and nuts.
the garden-hose connector 2 from
the fitting 1 on the bottom cowling.
onto a garden hose 3 which is con-
nected to a fresh-water supply.
tap and let the water flush through
the cooling passages for about 15
minutes. Turn off the water and dis-
connect the garden hose 3.
the garden-hose connector 2 on the
fitting 1 on the bottom cowling.
Tighten the connector securely.
E