Warming Up Engine; Electric Start And Prime Start Models; Shifting - Yamaha Z300 Owner's Manual

(on).
ECM00191
CAUTION:
Never turn the main switch to "
G
(start) while the engine is running.
Do not keep the starter motor turning
G
for more than 5 seconds. If the starter
motor is turned continuously for more
than 5 seconds, the battery will be
quickly discharged, thus making it im-
possible to start the engine. The starter
can also be damaged. If the engine will
not start after 5 seconds of cranking,
return the main switch to "
10 seconds, then crank the engine
again.
OFF
ON
START
EMU27670

Warming up engine

EMU27702

Electric start and prime start models

1. After starting the engine, allow it to idle
" (on), wait
ON
START
ZMU01881
ZMU04590
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Check for a steady flow of water from the
"
cooling water pilot hole.
ECM00511
CAUTION:
A continuous flow of water from the cool-
ing water pilot hole shows that the water
pump is pumping water through the cool-
ing passages. If water is not flowing out
of the hole at all times while the engine is
running, overheating and serious dam-
age could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
EMU27740
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM00220
CAUTION:
To change the boat direction or shifting
position from forward to reverse or vice-
versa, first close the throttle so that the
Operation

Shifting

ZMU01882
45