Reverse (Manual Tilt And Hydro Tilt Models); Stopping Engine; Procedure - Yamaha 25D Owner's Manual

Remote control models
1. Pull up the neutral interlock trigger (if
equipped) and move the remote control
lever quickly and firmly from neutral to
forward.
EMU27795
Reverse (manual tilt and hydro tilt
models)
EWM00190
WARNING
When operating in reverse, go slowly. Do
not open the throttle more than half. Oth-
erwise the boat could become unstable,
which could result in loss of control and
an accident.
Tiller control models
1. Place the throttle grip in the fully closed
position.
2. On models equipped with a tilt lock le-
ver, check that it is in the lock/down po-
N
F
ZMU03718
ZMU02030
sition.
3. Move the gear shift lever quickly and
firmly from neutral to reverse.
Remote control models
1. Check that the tilt lock lever is in the lock
position.
2. Pull up the neutral interlock trigger (if
equipped) and move the remote control
lever quickly and firmly from neutral to
reverse.
EMU27820

Stopping engine

Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU27832

Procedure

1. Push and hold the engine stop button
until the engine comes to a complete
stop.
Operation
ZMU03719
R
N
ZMU03720
26