Display; First Use - John Lewis JLWM 1203 Instruction Manual

The washing machine has stopped
with water in the tub, at the end of
the «Soak» programme or if the «Rinse
hold» option has been set: this is indicated
by a flashing zero. The «Door lock» pilot
light is still on. The door cannot be
opened.
The washing machine has
completed the programme: this is
indicated by a flashing zero. The «Door
lock» pilot light has gone off. It is now
possible to open the door.
• Delay start, a time value indicated in
hours and selected by the relevant button.
The delay time (20 hours max) is

First use

• Ensure that the electrical and
water connections comply with
the installation instructions.
• Remove the polystyrene block and
any material from the drum.
• Pour 2 litres of water into the main
wash compartment
detergent drawer in order to
activate the ECO valve. Then run
a cotton cycle at the highest
temperature without any laundry
in the machine, to remove any
manufacturing residue from the
drum and tub. Pour 1/2 a measure
of detergent into the main wash
compartment and start the
machine.
displayed for a few seconds, then the
duration of the selected programme
reappears. After you have pressed the
button 8, the countdown is updated every
hour, and, for the last hour, every minute.
• An incorrect option selection has
been made: this is indicated by the
message Err for a few seconds when an
option incompatible with the current
programme is selected.
• An alarm code indicates a fault with the
machine (see the relevant chapter).
of the
11