Programme Progress Display - Zanussi ZWG3106 User Manual

5. PRELAVADO button
Adds a pre-wash phase at the start of the cycle with
water heating to 30° C.
In COTTON and SYNTHETIC cycles, performs a
short spin before passing to the washing phase.This
option cannot be selected for LANA and LAVADO A
MANO cycles.
6. INICIO / PAUSA button
After selecting the required programme, by the
programme selector (see section 9), press this
button to start the machine; the corresponding
light stops flashing and will keep lighting until
the programme finishes.
To interrupt the running programme, depress
INICIO / PAUSA button: the corresponding
light starts to flash.
To restart the programme from the point at
which it was interrupted, press INICIO / PAUSA
button again.

7. Programme progress display

During programme development, the light
corresponding to the cycle phase which the machine
is in will illuminate. In other words, if the machine is
in the pre-wash or wash phases the light LAVADO
will come on; if it is in the rinses phase the light
will come on; if it is in the spin phase the light
will come on; and finally, if it is in the drain phase
the light will come on.
The light FIN will illuminate to indicate that the
selected programme has finished.
The light FIN flashes in the event of operating
problems:
• 4 flashes: door open.
• 2 flashes: problem with water draining.
• 1 flash: problem with water supply.
For more information see paragraph "Something not
working?" at the end of this booklet.
8. Spin speed selector dial or
no spin /
This dial allows the reduction of the final and the
intermediate spin speed or to select
RINSE HOLD options.
The speeds on the dials refer to cotton programmes.
The position 1000 r.p.m. corresponds to 900 r.p.m.
for synthetics and wool.
Position 500 r.p.m. is common for all fabrics.
• NO SPIN: by selecting this option all the
spinning phases are turned off. To be used for
extremely delicate items. The washing machine will
add 3 rinses in the cotton programmes and 1 rinse
in the synthetics programmes.
• RINSE HOLD: by selecting this option, the
water of the last rinse is not drained, in order to
prevent the fabrics from wrinkling. When the
programme has finished, FIN light will illuminate.
To drain the water follow these three steps:
A) Turn the programme selector dial to "
B) Select DRAIN or
C) Press INICIO / PAUSA button.
35
rinse hold options
NO SPIN or
O
".
SPIN programme.