Installation Instructions; For Customers In Europe - Tannoy POWER V6, POWER V8, POWER V12, POWER V12HP Owner's Manual

INSTALLATION INSTRUCTIONS

1 THIS PRODUCT MUST BE EARTHED. Use only a flexible cable or cord provided with a green or green and yellow core
which must be connected to the protective earthing terminal of the detachable Neutrik 'Powercon' type NEC3FCA
connector (Tannoy part number 3461 0919 as supplied with the equipment. The other end of the green or green and
yellow conductor must be connected to the earthing pin of a suitable mains plug or the earthing terminal of the installation.
The cord must be of maximum length 7.5 meters, rated SJ, SJT, or SJE, 10A minimum and be marked VW-1.
2 The electrical power connection to this product is only to be made via a detachable Neutrik 'Powercon' type NEC3FCA
connector (Tannoy part number 3461 0919) as supplied with the equipment. Wiring to this connector must only be made
by suitably qualified personnel and must comply with all local requirements.
3 Do not install this equipment in an enclosed space. Do not limit free ventilation and movement of air around the back
panel. Ensure that there is at least 100mm (4") of space around all sides of the product for ventilation.
4 Only use attachments and accessories approved by or specified by Tannoy.

FOR CUSTOMERS IN EUROPE

This product complies with both the LVD (electrical safety) 73/23/EEC and EMC (electromagnetic compatibility) 89/336/EEC
directives issues by the commission of the European community.
Compliance with these directives implies conformity with the following European standards:
EN60065
EN55103-1
EN55103-2
This product is intended for the following electromagnetic environments: E2; E3 & E4. Environment E1 (domestic) is specifically
excluded.
FOR CUSTOMERS IN THE USA & CANADA
This product has been tested for electrical safety and complies with:
UL60065 7th edition
CA /CSA C22.2 No.60065-03
EMC
This equipment has been designed to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment.
Industry Canada Class A emission compliance statement: This Class B digital apparatus complies with Canadian ICES-003.
Avis de conformite' a' la re'glementation d'Industrie Canada. Cet appareil nume'rique de classe A est conforme a' la norme
ICES-003.
2.0: INTRODUCTION
Power V™ is a range of active sound reinforcement loudspeakers equipped with the Tannoy Dual Concentric™, point source,
constant directivity drive unit technology. By combining the 'Dual' with a sophisticated amplifier package integrated within the
speaker cabinet, Power V™ is aimed at installation applications where uncompromised sound quality and flexibility is essential.
In order to satisfy a wide scope of fixed or on the road sound reinforcement applications there are five full range models and
two subwoofers in the Power V™ range; Power V6, Power V8, Power V12, Power V12HP and Power V15; along with the
subwoofers - Power VS10 BP and Power VS15 BP.
The location of the high frequency drive unit, in the throat of the low frequency driver, ensures that the driver delivers constant
directivity and unparalleled linearity from a true point source.
The spherical wave front delivered presents an even dispersion in both horizontal and vertical planes, providing exceptional
off-axis performance and an even response throughout a wide listening area. Overcoming the time alignment problems inherent
in a discretespeaker design the constant directivity characteristics of the 'Dual' exhibits better harmonic alignment, delivering
a more natural sound with superb tonal balance and greater intelligibility. This highly integrated driver design approach provides
a constant time delay over the frequency spectrum ensuring enhanced transient performance and sound quality.
4
Product safety
EMC emissions
EMC immunity