Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ryobi LCDI1402
Summary of Contents for Ryobi LCDI1402
- Page 1 LCDI1402 14.4 VOLT COMPACT HAMMER DRILL DRIVER OWNER’S OPERATING MANUAL...
- Page 2 DESCRIPTION Keyless chuck 15. Lock (tighten) Torque adjustment ring 16. Unlock (release) Quick mode selector 17. Low speed Two-speed gear train 18. High speed 5 . Rotation selector (forward/reverse/center lock) 19. Drive mode Bit storage 20. Drill mode Trigger switch 21.
- Page 3 Fig. 3 Fig. 6 Fig. 4 Fig. 7 Fig. 5 Fig. 8...
- Page 4 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
-
Page 5: General Power Tool Safety Warnings
English GENERAL POWER TOOL SAfETy WARNINGS protected supply. Use of an RCD reduces the risk of electric shock. NOTE: The term ''residual current device (RCD)'' WARNING may be replaced by the term ''ground fault circuit Read all safety warnings and all instructions. interrupter (GFCI)'' or ''earth leakage circuit breaker Failure to follow the warnings and instructions (ELCB)''. -
Page 6: Special Safety Rules
English GENERAL POWER TOOL SAfETy WARNINGS knowledge, unless they have been given supervi- sion or instruction concerning use of the appliance by a person responsible for their safety. Children Disconnect the plug from the power source and/ should be supervised to ensure that they do not or the battery pack from the power tool before play with the appliance. -
Page 7: Operation
English SPECIfICATIONS This product will accept RYOBI 14.4 V lithium-ion battery packs and RYOBI 14.4 V nickel-cadmium battery packs. BATTERy COMPATIBLE BATTERy PROTECTION fEATURES MODEL PACK CHARGER RYOBI 14.4 V lithium-ion batteries are designed with (not included) (not included) features that protect the lithium-ion cells and maximise 140262011 battery life. - Page 8 English OPERATION KEyLESS CHUCK See Figure 4. The drill has a keyless chuck to tighten or release drill TRIGGER SWITCH bits in the chuck jaws. The arrows on the chuck indicate See Figure 3. which direction to rotate the chuck body in order to LOCK ...
- Page 9 English OPERATION 1. APPLICATION 2. SPEED 3. MODE • Lag screws up to 9.5 mm dia. by 38.1 mm long 1/LOW DRILL MODE • Hole saw up to 38.1 mm (TORQUE ADJUSMENT NOT ACTIVE) • Spade bits up to 19.1 mm •...
-
Page 10: Maintenance
This is normal and is the action of the brake. MAINTENANCE WARNING When servicing, use only identical RYOBI replacement parts. Use of any other parts may create a hazard or cause product damage. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. - Page 12 961067428-01...