Lenovo ThinkPad T510 Hardware Maintenance Manual page 59

Table 2. Numeric error codes (continued)
Symptom or error
0187
EAIA data access error—The access to EEPROM is failed.
0188
Invalid RFID Serialization Information Area.
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190
Critical low-battery error
0191
System Security—Invalid Remote Change requested.
0192
System Security— Embedded Security hardware tamper
detected.
0193
RF antenna has been removed
0194
The computer has been carried through a security gate
0195
Security hardware tamper detected
0196
Security hardware removed
0197
Invalid remote change requested.
FRU or action, in sequence
System board.
System board.
System board.
1. Charge the battery pack.
2. Battery pack.
1. Run BIOS Setup Utility, and then save current
setting by pressing F10.
2. System board.
System board.
Enter the supervisor password.
Enter the supervisor password.
1. Enter BIOS Setup Utility by entering supervisor
password, and select "Password" --> " Security
Chip" --> "Clear Security Chip" to clear this error.
2. Security chip.
3. System board.
1. Enter BIOS Setup Utility by entering supervisor
password, and select "Password" --> " Security
Chip" --> "Clear Security Chip" to clear this error.
2. Security chip.
3. System board.
The remote configuration for the security chip has
failed. Confirm the operation and try again.
Chapter 4
.
Related service information
51