Chuck Removal; To Retighten A Loose Chuck - Ryobi CID1442P Operator's Manual

CHUCK REMOVAL

See Figures 11, 12, and 13.
I Lock the switch trigger by placing the direction of rotation
selector in center position. See Figure 3.
I Insert a 5/16 inch or larger hex key wrench into the chuck
of your drill and tighten the chuck jaws securely.
I Tap the hex key wrench sharply with a mallet in a
clockwise direction. See Figure 11. This will loosen the
screw in the chuck for easy removal.
I Open chuck jaws and remove hex key wrench. Remove
the chuck screw by turning it in a clockwise direction.
See Figure 12.
Note: The screw has left hand threads.
I Insert hex key wrench in chuck and tighten chuck jaws
securely. Tap sharply with a mallet in a counterclockwise
direction. This will loosen chuck on the spindle. It can
now be unscrewed by hand. See Figure 13.

TO RETIGHTEN A LOOSE CHUCK

The chuck may become loose on spindle and develop a
wobble. To tighten, follow these steps:
I Lock the switch trigger by placing the direction of rotation
selector in center position. See Figure 3.
I Open the chuck jaws.
I Insert hex key wrench into chuck and tighten chuck jaws
securely. Tap hex key wrench sharply with a mallet in a
clockwise direction. This will tighten chuck on the spindle.
I Open the chuck jaws and remove hex key wrench.
I Tighten the chuck screw.
Note: The chuck screw has left hand threads.
OPERATION
Page 13
Fig. 12
Fig. 13