Bissell SPOTLIFTER Powerbrush 1716 Series User Manual page 8

Maintenance & Care
to clean the dual powerbrush
notE: make sure the power Switch is in the
"off" ( o ) position and the unit is unplugged.
1. Firmly grasp the brush cartridge from the side
of the unit and pull out from the unit.
2. To remove any debris that may have
collected around the dual Powerbrushes, rinse
the brush cartridge under warm water.
3. Replace the brush cartridge into the unit by
gently guiding the cartridge in the unit. Once it
is in place, firmly "snap" the brush cartridge in
place.
notE: Do not attempt to remove or insert the
brush cartridge while the unit is running. this
will damage your unit.
Storage
store in a dry area, at room temperature
to avoid freezing.
to replace the powerbrush belt
if the belt should break, to replace:
1. Remove the screw in the belt cover using a
Phillips screwdriver.
2. Remove the broken belt.
3. Replace the new belt over the 2 belt gears.
4. Replace the belt cover door.
www.bissell.com
8
800.237.7691
WaRnInG
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
1.
3.
WaRnInG
To reduce the risk of fire, electric shock or injury,
unplug from outlet before servicing.
1.