Advertisement
Advertisement
Table of Contents
Related Manuals for Harman Kardon HK 970
Summary of Contents for Harman Kardon HK 970
- Page 1 HK 970 Integrated Amplifier OWNER’S MANUAL Power for the Digital Revolution ®...
-
Page 2: Table Of Contents
Table of Contents 3 Introduction 4 Connections 5 Controls and Functions 6 Remote Control 7 Operating Instructions 7 Troubleshooting 8 Specifications TABLE OF CONTENTS DECLARATION OF CONFORMITY We, Harman Consumer Group International 2, route de Tours F-72500 Château-du-Loir France declare in own responsibility, that the product described in this owners manual is in compliance with technical standards: EN 55013:2001 + A1:2003... -
Page 3: Introduction
Introduction Congratulations on your choice of the Harman Kardon HK 970 Integrated Amplifier. In order to obtain the best performance from this integrated amplifier, please be sure to read this owner's manual and use your integrated amplifier only in accordance with its instructions. -
Page 4: Connections
Input jacks on the back of your amplifier and, if available, the compo- nent’s Input/Record jacks to the Output jacks of the HK 970. Use the white, black or gray plugs to connect Left channel jacks; use the red plugs for Right channel jacks. -
Page 5: Controls And Functions
2 System Power Control: Press this button to turn on the HK 970; press it again to turn the unit off (to Standby). Note that the Power Indi- cator 1 next to the switch will turn blue when the unit is on. -
Page 6: Remote Control
Remote Control Independent Remote Control The system remote of the HK 970 can control the amplifier and compatible Tuners, CD Players and CD Recorders. The remote In jack of units without an integrated IR receiver must be connected to the amplifier's remote control output jack so that the system remote control can operate them. -
Page 7: Operating Instructions
Operating Instructions Listening to your CD player, tape deck, tuner or other source 1. Turn Volume control to minimum level and press the flat Power switch to turn on the amplifier. The power indicator lights blue and the protection circuitry checks for short circuit or other problems for a few seconds before sound output. -
Page 8: Specifications
Specifications Continuous Average Power Per Channel (FTC) 20 Hz – 20 kHz, both channels driven Dynamic Power (IHF, 1 kHz Tone Burst) High instantaneous current capability (HCC) Power Bandwidth @ Half-Rated output, 8Ω Frequency response @ 1W (+0/-3dB) Damping factor (20Hz-20k Hz) Signal-to-noise Ratio (Reference rated power output, A-WTD) Input sensitivity/Impedance Overload:...