Yamaha F9.9C Ower's Manual page 85

w
NOTE:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into
contact with the surface of the drain hole.
Then tighten 1/4 to 1/2 turn more. Tighten
the drain screw to the correct torque with a
torque wrench as soon as possible.
4) Remove the oil filler cap 2. Add the
correct amount of oil through the filler
hole.
Install the filler cap.
Engine oil grade and capacity:
See "Specifications" in this chapter.
5) Start the engine and watch to make
sure the oil pressure indicator turns on.
001520
Make sure that there are no oil leaks.
cC
If the oil pressure indicator does not turn
on, or if there are oil leaks, stop the
engine and find the cause. Continued
operation with a problem could cause
severe engine damage. Consult your
Yamaha dealer if the problem cannot be
located and corrected.
6) Turn off the engine and wait 3 minutes.
Recheck the oil level using the dipstick
to be sure the level falls between the
upper and lower marks. Fill with oil if it
is below the lower mark, or drain to the
specified level if it is above the upper
mark.
7) Dispose of used oil according to local
regulations.
000815
E
4-18