Table of Contents
Advertisement
Memorising operations in the Memory 2 buttons
for other equipment
You can assign only one function to each button. If you assign two functions to the button, the newer
one will be memorised (learn function).
Set the MEMORY 1/2 selector switch to MEMORY 2.
1
Move the LEARN/TRANSMIT selector switch to LEARN.
2
The red learn indicator will light up. Though the red and green
learn indicators light up alternately after approx. 15 seconds,
you can go on to the next step.
Press down the desired button on the remote control for 2
3
seconds or more.
The green learn indicator will flash (the red indicator remains lit).
Within 10 seconds, press down for more than 2 seconds
4
the desired button on the remote control supplied with
other equipment to send the signal to the
When the signal is sent to the remote control of the unit, the
green indicator will go off. When memorisation is completed,
it will light up.
Angle and distance
5 cm - 10 cm
If the signal is not memorised correctly, the red learn in-
dicator will flash.
Perform the operations from step 3 again.
Repeat steps 3 and 4 to memorise other buttons.
5
After memorisation is completed, move the LEARN/TRANSMIT selector switch to TRANSMIT.
6
You can use the remote control.
marking.
(2" - 4")
10˚
– 7 –
Lights up
Alternately light up
Lit Flashes
mark
Lit
Goes off
Lit Lights up
Flashes
Advertisement
Table of Contents
