Recording From The Radio; Erasing Recorded Tapes - Sharp CD-MPS660H Operation Manual

Sequential recording from several discs:
1 Perform steps 1 - 5 in "Recording from a CD or MP3 disc" on page
27.
2 Within 5 seconds, press the
23
To perform programmed recording:
1 Programme discs and tracks (see pages 18, 22).
2 Press the button.
3 Press the / button.
To stop recording:
Press the button.
The disc and tape will stop.

! Recording from the radio

1
Tune in to the desired station (see page 23).
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the / button to start recording.
To interrupt recording:
Press the button.
To resume recording, press the
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
! Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
/ button.
2
3
4
5
To stop dubbing:
Press the
TAPE 1 and TAPE 2 will simultaneously stop.

! Erasing recorded tapes

/ button. 1 Load the tape to be erased into the TAPE 2 cassette compart-
2 Press the TAPE (1
3 Press the
4 Press the
Note:
Make sure that the TAPE 1 is not in use.
Press the ON/STAND-BY button to turn the power on.
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
Press the button.
Recording will be paused.
Press the / button to start dubbing.
button.
ment with the side to be erased facing toward you.
2) button until "TAPE 2" appears on the dis-
play.
button.
/ button to start erasing.
03/12/19 CD-MPS660H(H)E3.fm
CD-MPS660H
ENGLISH
TAPE 1 TAPE 2
E-28
TINSZA035AWZZ
8