Listening To The Radio - Sharp XL-DV75HMKII Operation Manual

Listening to the radio

ON / ON /
STAND-BY STAND-BY
TUNING TUNING
PRESET PRESET
MEMORY MEMORY
TOP MENU TOP MENU
SUB TITLE SUB TITLE
/ DIGEST / DIGEST
Tuning
1 Press the ON/STAND-BY button to turn the power on.
2 Press the FUNCTION button repeatedly to select the TUNER
(FM) mode.
3 Press the TUNING ( or
station.
Manual tuning:
Press the TUNING ( or
to tune in to the desired station.
Auto tuning:
When the TUNING ( or
seconds, scanning will start automatically and the tuner will stop
at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop
automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING (
again.
When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator will
light up. Finally, the station name will appear.
Full auto tuning can be achieved for RDS stations "ASPM", see
page 27.
Tuning will stop when reach to 87.50 MHz or 108.00 MHz.
To receive an FM stereo transmission:
Press the AUDIO button to select FM mono or FM stereo.
"ST" will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the AUDIO button to
extinguish the "ST" indicator. The reception changes to
monaural, and the sound becomes clearer.
FM stereo mode indicator
ON / ON /
OPEN / CLOSE OPEN / CLOSE
STAND-BY STAND-BY
1 2 3
4 5 6
7 8 9
DIRECT DIRECT
0 10 10 TUNING TUNING
TUNING TUNING TUNING TUNING
PRESET PRESET PRESET PRESET
SETUP SETUP OSD OSD FUNCTION FUNCTION
PRESET PRESET
EQUALIZER EQUALIZER VOLUME VOLUME X-BASS X-BASS
MEMORY MEMORY MUTE MUTE
MENU/PBC MENU/PBC
FUNCTION FUNCTION
ENTER ENTER
RETURN RETURN
AUDIO AUDIO ZOOM ZOOM ANGLE ANGLE
SLOW SLOW STEP STEP RANDOM RANDOM
RDS RDS
ASPM / PTY ASPM / PTY DISP DISP A-B A-B
) button to tune in to the desired
) button as many times as required
) button is pressed for more than 0.5
or
Memorising a station
Up to 40 stations for FM band can be stored and recalled at the push
of a button. (PRESET (
1 Perform steps 1 - 3 in "Tuning".
2 Press the MEMORY button to enter the preset tuning saving
mode.
3 Within 6 seconds, press the Direct Search buttons to select the
preset channel number.
Enter the channel number using the Direct Search buttons.
To select channel 1: Press "0" and "1".
To select channel 12: Press "1" and "2".
4 Press MEMORY button to memorise the station. The preset is
memorised when the "MEM" indicator is gone.
If the "MEMORY" and preset number indicators disappear before
the station is memorised, repeat the operation from step 2
onwards.
5 Repeat steps 1 - 4 to set other stations or to change a preset
station.
When a new station is stored in memory, the station previously
memorised for that preset channel number will be erased.
Note:
The backup function protects the memorised stations for a few hours
should there be a power failure or the AC power lead become
disconnected.
To recall a memorised station
Press the PRESET (
) button
select the desired station.
E-26
or ))
or ) button for less than 0.5 seconds to