Sharp XL-DH10NH Operation Manual page 16

Listening to the iPod (continued)
■ To insert iPod adaptor
1
Press the ON/STAND-BY button to turn the power on.
2
Open the iPod cover by pulling up the tip.
pull up
3
Insert the iPod adaptor into the iPod dock and connect
your iPod.
iPod (bottom)
Dock connector
iPod adaptor
iPod dock
iPod
connector
Notes:
●
The unit is installed with the iPod adaptor No. A.
●
Remove and insert the recommended iPod adaptor if
required (refer table on page 6).
■ To remove iPod adaptor
Insert the tip of a screwdriver ("–" type, small) into the iPod
adaptor hole as shown and lift upward to remove.
iPod
■ iPod playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod button on the remote control or
FUNCTION button on the main unit repeatedly to
select iPod function.
3
Insert iPod unit in iPod dock of main unit.
4
Press the
■ To disconnect iPod
Simply remove the iPod from the iPod dock. It is safe to do
so even during playback.
■ Navigating the iPod menus
1
Press the MENU button to view the menu on iPod unit.
Press it again to go back to previous menu.
2
Use the
and then press ENTER button.
Note:
When navigating the iPod menus with remote control, do
not operate any of the buttons on the iPod unit. The volume
level is adjusted by pressing the VOL (+ or –) button on the
main unit or the remote control. Adjusting the volume on
the iPod unit gives no effect.
iPod operation:
The operations described below depend on the generation
iPod you are using.
System on operation:
When the main unit is powered on, the iPod unit will
automatically power on when docked in the unit (including
TIMER function).
System off (stand-by) operation:
When the main unit is turned to stand-by mode, the docked
iPod unit will automatically turn to charging mode.
E-7
CD
USB
MUTE MUTE
CLOCK/TIMER CLOCK/TIMER
TUNING/
FOLDER
PTY PTY
RDS RDS
AUX AUX
/ button to start playback.
or button to select an item on the menu