Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Tricity Bendix TDF222
Summary of Contents for Tricity Bendix TDF222
- Page 1 User manual Dishwasher TDF222...
-
Page 2: Table Of Contents
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. -
Page 3: Safety Information
Safety information • Under no circumstances should you attempt In the interest of your safety and to ensure the to repair the machine yourself. Repairs car- correct use, before installing and first using the ried out by inexperienced persons will cause appliance, read this user manual carefully, in- injury or serious malfunctioning. -
Page 4: Control Panel
Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine. - Page 5 Programme selector dial and On/Off switch • when in this position, the machine is switched off (corresponding light off), • when the marker on the dial corresponds with a programme, the machine is switched on and a pro- gramme is selected (programme selector indicator light on) Start/cancel button •...
-
Page 6: Washing Programmes
Indicator lights End indicator light Illuminates when the washing programme has ended. Switch off the dishwasher by returning the programme selector dial to the Off position. The On/Off indicator light turns off. It also has added functions of visual signalling as: –... -
Page 7: First Use
First use Check whether these detergents are suitable Before using your dishwasher for the first time: for your water hardness. Follow the manufac- • Ensure that the electrical and water connec- turers instructions. tions comply with the installation instructions – Set the water hardness to level 1. •... - Page 8 Water hardness is measured in equivalent The softener should be adjusted according to scales, Clarke degrees, French degrees (°TH) the hardness of the water in your area. Your and mmol/l (millimol per litre - international unit local Water Authority can advise you on the for the hardness of water).
-
Page 9: Filling With Dishwasher Salt
Setting the water softener electronically (see table) The water softener is factory set at position 5. The dishwasher must be switched off . Release the button. The end of programme indicator light will flash. The number of flashes corresponds to current level set. -
Page 10: Filling With Rinse Aid
IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT! Top up the special salt when the light on the control panel illuminates. -
Page 11: Adjusting The Dosage Of Rinse Aid
Adjusting the dosage of rinse aid Increase the dose if there are drops of water or Reduce the dose if there are whitish streaks on lime spots on the dishes after washing. the dishes or a bluish film on glassware or knife blades. - Page 12 For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-of- • Only wash stoneware in the dishwasher if it is pearls handles. specially marked as being dishwasher-safe by the manufacturer.
-
Page 13: Upper Basket
Load upper basket. Light For taller items, the cup If plates are to be loaded in the upper basket: load items (plastic bowls etc.) racks can be folded up- them starting from the rear positions; tilting them must be loaded in the up- wards. -
Page 14: Use Of Detergent
IMPORTANT! IMPORTANT! Never lift or lower the basket on one side only When the basket is in the higher position you will not be able to use the cup racks. Use of detergent IMPORTANT! Observe the manufacturer’s dosing and stor- age recommendations. -
Page 15: Unloading The Dishwasher
Unloading the dishwasher • Hot dishes are sensitive to knocks. • Water may appear on the sides and the door The dishes should therefore be allowed to of the dishwasher as the stainless steel will cool down before removing from the appli- eventually become cooler than the dishes. -
Page 16: Cleaning The Spray Arms
Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. Cleaning the spray arms Prolonged periods of non- operation NEVER try to remove the spray arms. -
Page 17: Environmental Concerns
3. Remove the water inlet and discharge ho- Avoid over tilting the machine during transpor- ses. tation. 4. Pull the machine out together with the ho- ses. Environmental concerns Packaging material The symbol on the product or on its pack- aging indicates that this product may not be The packaging materials are environmentally treated as household waste. - Page 18 Fault code and malfunction Possible cause and solution • continuous flashing of the start/cancel indicator • The water tap is blocked or furred with limescale light Clean the water tap • 1 flash of the end of programme indicator light •...
-
Page 19: Consumption Values
So that you always have these numbers at Mod. : ..... . . hand, we recommend you to make a note of PNC :. -
Page 20: Technical Data
Consumption values Programme Programme duration (in Energy consumption (in Water (litres) minutes) kWh) 1 POWER WASH 65° 120-130 1,8-2,0 22-24 2 NORMAL WASH 65° 105-115 1,5-1,7 23-25 3 QUICK WASH 65° 1,05 4 BIO WASH 50° Technical data Dimensions Width x Height x Depth 60,0 x 85,0x 61,0 Electrical connection Information on the electrical connection is given on the rating plate on the... -
Page 21: Installation
Full load: 12 standard place settings Rinse aid setting position 4 (Type III) Upper basket Cutlery basket Lower basket cup racks: position A Installation (max. 60°) or cold water. Nevertheless we ad- WARNING! vise you a cold water supply. Any electrical and/or plumbing work required to install this appliance should be carried out by a WARNING! qualified electrician and/or plumber or compe-... -
Page 22: Inlet Hose
Inlet hose Connect the inlet hose to a water tap with an external thread of 3/4”. The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks. -
Page 23: Electrical Connection
Electrical connection ble has to be replaced, contact your local Serv- ice Force centre. The plug must be accessible after the appliance CAUTION! has been installed. Safety standards require the appliance to be Never unplug the appliance by pulling on the earthed. - Page 24 www.electrolux.com www.tricity-bendix.co.uk 156991360-00-012008...