Once the top of the panel has been correctly posi-
tioned, fix it through the holes in the bottom bracket,
without tightening the screws (Fig. 10).
D471
Check the position again by slackening the screws
and pins then, once the best position has been ob-
tained, fully tighten all the fixings.
Cover the visible part of the top bracket on the panel
with plastic cover (D), inserting it in the locations pro-
vided in the bracket.
D
D472
Once the door has ben correctly aligned, tighten the
holding nuts on the fixing brackets and attach the ap-
pliance to the adjacent units and the bottom of the
work surface (Fig. 12).
Fig. 10
If the appliance has been fitted into a space 820 mm
high and the maximum height of the base plate is 100
mm, fit the front cover plate by pushing the two verti-
cal lugs into the rectangular holes on the bottom side
of the ventilation duct until they click. The plate can be
adjusted backwards or forwards in the holes (Fig. 13).
Fig. 11
170
220
Fig. 12
Fig. 13
820
870
135
185
9