Table of Contents
Advertisement
Adjusting the worktop
You can move the worktop forward or backward by
25 mm in order to align the machine with other kitchen units.
Simply unscrew the two rear retaining screws, move the top
to the required position and then retighten the screws.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine's worktop, you can install it under
a close fitting sink unit or a pre-existing top, providing the
dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
-
Remove the machine's worktop by unscrewing the
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with
the adjustable feet. When inserting the machine, ensure that
the water inlet and drain hoses are not kinked or squashed.
Technical specifications
Dimensions
Electrical connection
Motor rating during wash
Power of heating element
Overall power
Water supply pressure
Capacity
IN26
IN05
Width
Height with worktop
Height without worktop
Max depth
Max depth with open door
Voltage
Minimum
Maximum
7
60 cm
85 cm
82 cm
55.5 cm
115,2cm
220/240 V - 50 Hz
200 W
2100 W
2300 W
50 kPa (0.5 bar)
800 kPa (8 bar)
12 place settings
Advertisement
Table of Contents
