Step 5: Installing The Bottom Trim - Thermador SEC271 Installation Instructions Manual

STEP 5: INSTALLING THE BOTTOM TRIM

Install the bottom vent trim and secure with
the 2 screws provided, one at each top end
corner of the trim. The sheet metal bottom
of the oven should be under the trim, except
for the section at the center. To install the
screws, open the door. The holes are visible
at each end below the left and right hinges.
Place and tighten screws. See Fig. 5 View 'A'.
STEP 6: INSTALLING THE OVEN RACKS
Grasp rack rack firmly on both sides. Tilt rack
up to allow stop into rack holder. Bring rack
to a horizontal position and push the rest of
the way in. Rack should be straight and flat,
not crooked.
CAUTION
Always insert racks with pot stops toward the back
of the oven and facing up. If inserted incorrectly,
the rack could come all the way out of the oven
causing injury and/or burns
Fig. 5 - Installing Bottom Trim
1 0
View 'A'
Side
View
'A'