Power Trim And Tilt Switches (Twin Binnacle Type); Trim Tab With Anode - Yamaha F200 Owner's Manual

Basic components
NOTE:
For instructions on using the power trim and
tilt switch, see page 37.
EMU26161
Power trim and tilt switches (twin
binnacle type)
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pushing the switch "
board motor up, then tilts it up. Pressing the
switch " " (down) tilts the outboard motor
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
1
DN
UP
1. Power trim and tilt switch
NOTE:
On the dual engine control, the switch on
G
the remote control grip controls both out-
board motors at the same time.
For instructions on using the power trim and
G
tilt switches, see pages 35 and 37.
EMU26241

Trim tab with anode

The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
17
" (up) trims the out-
ZMU04601
EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run af-
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
If the boat tends to veer the left (port side),
turn the trim tab rear end to the port side "A" in
the figure. If the boat tends to veer the right
(starboard side), turn the trim tab end to the
starboard side "B" in the figure.
ECM00840
CAUTION:
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it will
become ineffective as an anode.
1. Trim tab
2. Bolt
3. Cap