Advertisement
Making a Circle Cut.
1.
Assemble the circle cutter assembly onto the tool as
previously discussed.
2.
On the tile, mark the center point of the circle, and
measure or mark the circumference of the intended circle
cut.
3.
Squeeze the Press Handle (#A) downward, lifting the drill
point and knife body above the level of the cutter base.
4.
Place the tile on the EVA cushion, with the centerpoint of
the circle directly under the center drill of the circle cutter.
Release the Press Handle slowly, and adjust the tile to
carefully align the Triangle Drill (#G) with the enter point of
the hole marked on your tile.
5.
Loosen the nut on the Knife Body (#F), and slide the knife
body until the knife point aligns with the circumference you
have marked on the tile. Retighten the nut.
6.
Holding the tile firmly onto the EVA Cushion, rotate the
Crank (#B) clockwise to drill into the tile, and cut the
circle. Continue rotating the crank until the circle has been
completely cut through the tile.
pLEASE READ THE FOLLOWINg CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY: NEITHER THE
MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND
TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT: IN FACT THE MANUFACTURER A
ND/OR DISTRIBUTOR EXPRESSLY STATES THATALL
REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT
OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.
Page 7 SKU # 41711
Figure 6. Adjusting the Circle Scale.
Figure 7. Locating the Tile Before Re-
leasing the Press Handle.
Figure 8. Turning the Crank to
Cut a Circle Hole.
Advertisement
