Oldsmobile Bravada 2002 Owner's Manual page 76

3. You are now ready to program the automatic door
locks. Select one of the three programming options
listed above, and press the lock side of the power
door lock switch to cycle through the lock options.
You will have 30 seconds to begin programming.
If you exceed the 30 second limit, the locks will
automatically lock and unlock and the horn will
chirp twice to indicate that you have left the program
mode. If this occurs, repeat the procedure beginning
-
with Step 1 to re enter the programming mode.
You can exit the program mode any time by turning the
ignition to RUN (the locks will automatically lock and
unlock and the horn will chirp twice to indicate that
you are leaving the program mode). If the lock/unlock
switches are not pressed while in the programming mode,
the current auto lock/unlock setting will not be modified.
See your dealer for more information.
2-8
Programmable Unlocking Feature
The following is the list of available programming options:
D
Mode 1: Driver's door unlocks when the
transmission is shifted into PARK (P).
D
Mode 2: All doors unlock when the transmission is
shifted into PARK (P)
D
Mode 3: All doors unlock when the key is removed
from the ignition.
D
Mode 4: No automatic door unlock.
The automatic door locks were pre
factory to unlock the driver's door once the transmission
is shifted to PARK (P). The following instructions detail
how to program your door locks differently than the
factory setting. Choose one of the four programming
options listed above before entering the program mode.
To enter the program mode you need to do
the following:
1. Begin with the ignition off. Then pull the turn
signal/multifunction lever toward you and hold it
there while you perform the next step.
-
programmed at the