Maintenance - Central Pneumatic 113 Assembly And Operating Instructions Manual

High speed air body saw
Table of Contents

Advertisement

Using the Saw
Note: Always press lightly when cutting. Do not force the Saw. Sudden forceful
pressing will shorten the stroke, diminish cutting efficiency, or possibly break
the blade.
Note: Always operate the Saw with two hands. Hold the top of the Housing (28)
with one hand, and hold the lower Housing (28) and Throttle Lever (13) with
the other. Failure to use two hands may cause the Saw to vibrate out of your
control causing serious injury.
Warning! This Saw may be used for cutting through copper, steel, aluminum,
and plastics. Do not exceed the maximum 16 gauge thickness when
cutting with this Saw. Doing so can cause serious injury and damage
to the tool.
Warning!
Check the saw blade prior to each use. Do not use a cracked, bent, or
broken blade.
1.
Secure the workpiece in a vise, or clamp it securely to a workbench.
2.
Following the directions on page 4, attach the Saw to the air source hose.
Push the Throttle Safety forward (see FIGURE 1 on page 5) and pull the Throttle
3.
Lever (13).
4.
Contact the workpiece allowing the Saw to do the cutting for you. Do not exert pressure
on the workpiece.
5.
When finished, release the Throttle Lever (13) and disconnect the Saw from the air
source.
After disconnecting the Saw from the air compressor, there could
still be enough air pressure to activate the Saw. Always position the Saw
safely and activate the Throttle Lever (13) repeatedly to make sure all of
the air is expended.
1.
After each use, wipe down the Saw with a lint free cloth.
2.
Make sure that both the housing that holds the blades and the Air Inlet (9) are free of
dirt and debris.
3.
Periodically apply a light machine oil to the pivot point of the Throttle Lever (13). See
FIGURE 1 on page 5.
4.
Before each use, check the blade to make sure it is securely in place. If necessary,
tighten the Set Screws (30).
5.
Before each use, make sure the Blade Guard (34) is securely in place. Tighten if
necessary.
SKU 113
Operation (continued)

Maintenance

Page 6
REV 09f

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents