Preparations; Charging Battery; Inserting Battery And Card - Panasonic LUMIX DMC-TZ4 Operating Instructions Manual

1

Charging battery

Preparations

Always charge before first use! (not sold pre-charged)
Charger (model-specific)
Charging light (CHARGE)
On: Charging in progress (approx. 120 min.)
Off: Charging complete
If light is flashing:
• Charging may take longer than normal if
battery temperature is too high or too low
(charging may not be completed).
• Battery/charger connector is dirty. Clean with
dry a cloth.
Approximate battery life
Number of pictures : 300 [330
•
(equivalent to approx. 150 [165
Values based on CIPA standards. (P.99)
1
Number reduced if intervals longer – 75 [82
Playback time: Approx. 360 [380
•
Above figures may be reduced if intervals between recordings are longer; if flash, zoom,
or LCD MODE are used frequently; or in colder climates (depends on actual usage).
DMC-TZ4
2
Battery will be warm during charging and for some time thereafter.
Battery will run out if not used for long periods of time, even after being charged.
Charge the battery with the charger indoors (10 °C-35 °C).
Frequently charging up battery is not recommended.
(Frequently charging battery reduces maximum usage time and can cause battery to expand.)
Do not disassemble or modify the charger.
If available battery power is significantly reduced, battery is reaching end of lifespan. Please
purchase a new battery.
The battery charger is in the standby condition when the AC power supply cord is connected.
The primary circuit is always "live" as long as the power cord is connected to an electrical outlet.
16
VQT1P91
Battery (model-specific)
1
Insert the battery
terminals and attach
the battery to the
charger
Ensure 'LUMIX' faces
outwards.
2
Connect the AC mains lead
The AC mains lead does
not fit entirely into the AC
input terminal. A gap will
remain as shown above.
3
Detach the battery
after charging is
complete
Disconnect charger and
battery when charging is
complete.
] (at 30-sec intervals)
] mins)
2
] pictures if 2-minute intervals
2
] mins
2

Inserting battery and card

Preparations
Battery (check orientation)
Card (check orientation)
Do not touch terminal
Status indicator
To remove
• To remove battery:
move lever in
Lever
direction of arrow.
Always use genuine Panasonic batteries (CGA-S007E).
If you use other batteries, we cannot guarantee the quality of this product.
Do not remove card or battery while power is 'ON' or while status indicator is on
(Camera may cease operating correctly, or card/recorded contents may be damaged).
The reading/writing speed of a MultiMediaCard is slower than an SD memory card.
When a MultiMediaCard is used, the performance of certain features may be slightly
slower than advertised.
Keep the Memory Card out of reach of children to prevent swallowing.
SD memory card/
SDHC memory card (optional)
1
Set the camera ON/OFF switch to OFF
Slide to the 'OPEN' position
and open the lid
OPEN
LOCK
Release lever
2
Completely insert battery
and card
(both click into place)
3
Close lid
Slide to the 'LOCK' position.
• To remove card:
press down in
centre.
VQT1P91
17