Table of Contents
Advertisement
The accessory profiles do not appear in the phone's menu until you connect
the headset, car kit or loopset.
Accessory profile allows you to adjust settings related to the accessory,
such as ring tone.
Set automatic answer
This profile lets your phone answer incoming calls after just one ring.
Note: This profile is available only when your phone is connected
to a headset, loopset or to an approved car kit. This feature applies
only to voice calls.
1 Press Menu 4 6 (Settings > Accessory settings).
2 Scroll to Headset, Handsfree or Loopset then press Select.
3 Scroll to Automatic answer, then press Select.
4 Scroll to On and press OK.
Set up the loopset profile
The LPS-3 Loopset gives people with T-coil equipped hearing aids the
ability to make and receive calls without noise interference.
Important: Refer to the booklet that comes with the LPS-3 for
complete instructions and safety information.
1 Plug the loopset jack into the bottom of your phone.
2 Press Menu 4 6 3 (Settings > Accessory settings > Loopset).
3 Scroll to Use loopset, then press Select.
4 Scroll to Yes, then press OK.
Note: The headset is the default accessory. If you follow steps 1 - 4
above, you set the loopset as the default accessory recognized by
your phone.
Personalize your phone
[ 73 ]
12
Advertisement
Table of Contents
