On-Screen Messages - Panasonic Viera TX-L42WT50B Operating Instructions Manual

On-screen messages

Message
All tuning data will be erased
Are you sure ?
Are you sure you want to
delete this timer ?
Press OK to delete timer.
Press RETURN to return.
Bad signal
Child Lock is active!
Press OK to enter PIN.
External Recording Due to
Start
Faulty dish
Feature not available.
Feature not available.
Press OK to view how it works.
Found new software version
.
Press OK to start update (may
take over 40 mins) or press
EXIT to ignore and you can
update when TV is in standby
Invalid operation - Please
check settings and
connections.
Invalid system time. Please
exit !
Invalid system time, Timer
Programming will not work.
Please press TV button on
remote control and check time
display on Banner
Max. number of timers already
set !
New channels found!
Press OK to update channel
list.
Press EXIT to ignore.
No channel found.
Please check aerial or local
signal availability.
Press OK to start Auto Setup.
No module inserted
No recording - Already
recording
[Shipping Condition] will erase all tuning data.
Confirm correct operation.
Confirm correct operation.
The signal is weak. Check the aerial / dish is plugged in properly. It may be
necessary to have an aerial / dish installer check the signal and aerial / dish
alignment.
Reset channels. (p. 56, 57)
The selected channel is locked in Child Lock (p. 66). You must enter the PIN
number before the channel will be displayed.
This message will appear 2 minutes before timer programming event for
external recording due to start.
The satellite cable might be short-circuited or there might be connection
problems of the cable. Check the cable and connection and then turn the TV
off with the Mains power On / Off switch, and turn it on again.
If the message still persists, consult a dish installer for checking the dish and
cable.
It is not possible to record from AV2 (COMPONENT) or HDMI. Connect the
recorder to the TV using a fully wired SCART cable for recording from the TV
tuner.
Confirm Q-Link or VIERA Link settings.
The selected feature on VIERA TOOLS is not available. Press the OK button to
view the demonstration to explain how to use it.
There is a new software available.
Check the Q-Link or VIERA Link connection and setting.
(p. 97 - 100)
Cannot get the time information and cannot edit Timer Programming screen.
Check the connection of the RF cable.
Cannot get the time information. If there is no time displayed on the Information
banner, check the connection of the RF cable.
The maximum number of timer programming events is 15.
There may be new channels available.
This message will appear each time a change is made by the broadcasters.
This message can be deactivated by setting [New Channel Message] to [Off] in
[DVB Tuning Menu].
Selecting OK will perform [Update Channel List].
Follow the on-screen instructions.
Please also refer to p. 116.
If channels are still not found, consult your local Panasonic dealer.
Check the CI module is inserted completely (p. 69).
The equipment may already be recording.
Meaning / Action
(p. 67)
(p. 97 - 100)
119