(Kd-R536 Only) - JVC KD-R536 Instructions Manual

*5
(Subwoofer)
*6
(Subwoofer low-
pass filter)
*6
(Subwoofer level)
*6
(High-pass filter)
(Keytouch tone)
*7
(Telephone
muting)
*8
(Amplifier gain)
(Monaural mode)
(Intermediate
frequency band)
(iPod/iPhone control)
*9
*9
(Front auxiliary
input)
*9
(Rear auxiliary
input)
*5 Displayed only when <L/O MODE> is set to <SUB.W>.
*6 Displayed only when <SUB.W> is set to <ON>.
*7 This setting does not work if <BT ADAPTER> is selected for <R-AUX> of <SRC SELECT>.
*8 The volume level automatically changes to "VOLUME 30" if you change to <LOW POWER>
with the volume level set to higher than "VOLUME 30".
*9 Displayed only when the unit is in any source other than the corresponding source "AM/
F-AUX/R-AUX/BT AUDIO".
: Cancels.
: Turns on the subwoofer output.
/
lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer.
: Adjusts the subwoofer output level.
/
Audio signal with frequencies lower than 100 Hz/120 Hz/150 Hz are cut off
from the front/rear speakers.
: Deactivates. (All signals are sent to the front/rear speakers.)
/ : Activates or deactivates the keypress tone.
: Mutes the sounds while using the cellular phone (not connected
through KS-BTA100).
: Cancels.
: VOLUME 00 — VOLUME 30 (Select if the maximum power of
each speaker is less than 50 W to prevent damaging the speakers.)
: VOLUME 00 — VOLUME 50
For settings, page 6. (Displayed only when the source is "FM".)
Displayed only when the source is "FM".
: Enables stereo FM reception.
: Improves the FM reception but stereo effect will be lost.
: Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
: Subject to interference noises from adjacent stations, but sound
quality will not be degraded and the stereo effect will remain.
For settings, page 6.
/
For settings, page 8. (Displayed only when the source is "USB-IPOD".)

(KD-R536 only)

/ : Enables or disables "AM" in source selection.
/ : Enables or disables "F-AUX" in source selection.
/ : Enables or disables "R-AUX" in source selection.
: Select if the rear auxiliary input jack is connected to the
Bluetooth adapter, KS-BTA100 (
changed to "BT AUDIO".
/ : Audio signals with frequencies
/ : Activates the High Pass Filter.
/ :
page 9). The source name will be
ENGLISH | 13