Default Mode On Stop
The Modes page appears as follows:
Touch-pads
Default Mode on stop
These Touch-pads allow you to define the modes which the switches and faders will
go into when the Tape Machine stops. The options are: ARMED, WRITE,
MANUAL and READ.
In practice you should set these to Read or Armed as these are modes where the
existing mix data will be played back. This reduces the chance of accidentally
overwriting a mix which is approaching perfection.
Global Status
These Touch-pads allow you to select or de-select the effect of the Global Mode
switches on the Stereo Master panel. The options are: ON and OFF.
Switch Select. Pressing this takes you to the Switch Select On Tape Stop page.
Exit
To Exit, press the Set-up button.
DC2020 The Automation Pages
4.67