Panasonic TH-42LF25ER Operating Instructions Manual page 23

H-Pos Adjust the horizontal position.
H-Size Adjust the horizontal size.
Clock (During Component, RGB and PC input signal)
Phase Eliminate the fl ickering and distortion.
Dot Clock (During Component, RGB and PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
adjust so that any such noise is minimized.
Over scan Turn image over scan On/Off.
Confi gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)
On
Notes:
• "Off" is effective during only "16:9" aspect mode.
• When "Off" is set, "H-Size" and "V-Size" cannot be adjusted.
1:1 Pixel Adjusts the display size when 1125i or 1125p signal is input.
Mode Notes:
• "On" is effective during only "16:9" aspect mode.
• Select On when you would like to replay 1920 × 1080 input signal.
• Applicable input signal;
1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p
• Select Off when fl ickering is shown around the image.
• H-Size and V-Size cannot be adjusted when On is selected.
Off
Helpful Hint (
While the Pos. / Size display is active, if either the N button on the remote control is pressed at any time or the ACTION ( ) button is
pressed during "Normalise", then all adjustment values (except "Clock Phase" and "Dot Clock") are returned to the factory settings.
Off
On
/ Normalisation)
Normalise
Adjusting POS. /SIZE
V-Pos Adjust the vertical position.
V-Size Adjust the vertical size.
23