Creating A New Station Table; Shipping Condition/Factory Defaults - Panasonic NV-VP31EB Operating Instructions Manual

Manual Functions
Tuning
Manual
Auto Setup
Shipping condition
Owner ID
OK?
ENTER : yes EXIT : no
Auto Setup
Tuning : Ch 1
Tuning
Manual
Auto Setup
Shipping condition
Owner ID
OK?
ENTER : yes EXIT : no

Creating a new station table

Press MENU, the Menu screen appears.
With select the Tuning menu, confirm with ENTER.
With select [Auto Setup], confirm with ENTER.
Press ENTER to confirm.
The Auto Setup menu will be displayed.
The Automatic Tuning will start.
When no stations have been set, confirm all connections and restart Auto Setup.
You can restart Auto Setup, without using remote controller, by pressing some
buttons on the front of the unit. Hold down
simultaneously for about 5 seconds.

Shipping condition/factory defaults

Shipping condition resets the VCR back to the original factory settings except
Owner ID information. This is useful if the VCR is going to be used in a new
location as auto-setup will begin again when the unit is switched on (after
connecting to aerial and mains).
Press MENU, the Menu screen appears.
With select the Tuning menu, confirm with ENTER.
With select [Shipping condition] and confirm with ENTER.
Press ENTER to confirm.
To re-tune the VCR, disconnect and reconnect the AC Mains lead.
and on the main unit
35