Avr 4 Remote Control; Using The Avr 4 Remote Control - NAD T 757 Owner's Manual

USING THE AVR 4 REMOTE CONTROL

The AVR 4 remote control handset handles the key functions of the T 757. The AVR 4 can also be
used to directly command other NAD products that respond to applicable common remote control
codes. This includes other NAD Stereo Receiver, Integrated Amplifier and Preamplifier models. It has
additional controls to remotely operate NAD Blu-ray Disc Players, AM/FM Tuners and dedicated AM/
FM/DB Tuners. It will operate up to a distance of 23ft (7m). Alkaline batteries are recommended for
maximum operating life. Two AA batteries should be fitted in the battery compartment at the rear of
the Remote Control handset. When replacing batteries, check that they have been put in the right way
round, as indicated on the base of the battery compartment.
NOTE
The remote control handset supplied with the T 757 is of a universal NAD type, designed to operate
several NAD models. Some buttons are applicable only to specific NAD models. Contact your dealer
or NAD audio specialist for assistance.
1 ON, OFF
The AVR 4 remote has a separate ON and OFF button.
• Press ON button to switch the T 757 from Standby to operating mode. Press OFF button to
switch the T 757 to Standby mode.
2 DEVICE SELECTOR
A Device Selector button determines only what component the AVR 4 will command; it does not
perform any function on the T 757.
• Press desired Device Selector button for the applicable buttons to be directed to a "page" of
commands relevant to the selected device. Upon selecting a Device, you can now press the
corresponding AVR 4 control buttons applicable for the selected Device.
3 INPUT SELECTORS
Refer to the corresponding labels printed in the remote control faceplate and their respective
assigned buttons to make use of these functions.
• Set the DEVICE SELECTOR to "AMP" in order to gain access to these buttons.
• INPUT 1, INPUT 2 up to INPUT 7 corresponds to T 757's Source 1, Source 2 up to Source 7. Select
FRONT to select Front Input and MP for Front Audio MP input.
4 NUMERIC KEYS
The numeric keys allow for direct input of tracks for CD players and direct channel/preset access for
tuners and receivers.
5 A/V PSET
In combination with the numeric keys, press a Preset number from 1 to 5 as referenced to A/V
Presets settings. Note that the Preset settings can be configured via the A/V Presets menu.
6 DIMMER
• Reduce or restore VFD brightness.
• Depending on the NAD model, the brightness of the front panel display will vary when you
toggle this button.
• Use with NAD T 757 and other compatible NAD Stereo Receiver, Tuner and CD Player models.
7 TEST
Initiate speaker TEST mode while at the Speaker Levels section of the Speaker Setup menu.
8 MUTE
• Temporarily mutes audio output or restores audio from mute mode.
• MUTE mode is indicated by flashing Standby LED indicator for NAD Integrated Amplifiers or
"Mute" shown in the VFD of NAD Receivers.
• Adjusting the volume level via the AVR 4 or the front panel volume knob will automatically
release the mute function.
9 SURR
Select desired listening or surround mode.
IDENTIFICATION OF CONTROLS

AVR 4 REMOTE CONTROL

1
3, 4
5
8
14
13
2
7
6
9
10
11
12
15
11